Products > Rubber to Metal Bonded >> High Deflection Mount
Flanged High Deflection Mount E-B
A range of high deflection mounts has been added to our range targetted at applications requiring higher deflection than normally provided by solid rubber based mounts.
The range includes variants with blind and through tapped holes in the top plate in addition to plain through holes requiring a nut for assembly.
Where additional deflection is required, these mounts can be used in series. When used in pairs as shown here, the deflection can be effectively doubled for the same loading. It is best practice to ensure that the top surface is fully covered with an overlap of 20% of the top plate diameter.
This mount is designed for optimum loads of 40 or 65Kg. Rubber hardnesses of 40Sh and 50Sh are used to provide this difference. This mount has a through tapped hole. The metal parts are RoHS compliant zinc plated. Dimensions are as shown below:
Model
Rubber Hardness ShA
Max Load Kg
Deflection mm
E-B-75-40
40
40
4.4
E-B-75-50
50
65
5.3
E-B-95
This mount is designed for optimum loads of 70 or 130Kg and is a larger version of the E-B-75but with a blind tapped hole in the top plate. Metal parts are RoHS compliant zinc plated.
Model
Rubber Hardness ShA
Max Load Kgs
Deflection mm
E-B-95-40
40
70
6.2
E-B-95-50
50
130
4.9
E-B-100, 150 & 200
These mounts are the largest in the range, supporting up to 825Kg each. These have a plain top hole to allow a variety of fixing methods including series mounting.
Model
A
B
C
D
E
F
G
H
I
Optimal Load Kg
Deflection in mm
B-100
100
25
10
52
4
148
124
3
10
160
5
B-150
150
35
15
78
5
214
182
4
12
250
7,4
B-200
200
40
18
130
5
280
240
5
14
825
7
Future Developments
A range of additional models is planned for introduction later in November 2007.
The smallest of these will be the E-B-40 shown below:
